Temp.test select window (Control)

note

You can only open the Temp.test select window from the Start Condition window.

Use this window to remove tests from the current control analysis. The tests displayed at the window are those selected in the Test Select window.

note

All tests are automatically selected again when you run the next control analysis.

Removing tests from this control analysis

  1. At the Start Conditions window, select Temp.item select.

The Temp.test select window opens.

  1. At the Temp.test select window, clear the check box next to each test.

note

To clear all tests, select Clear, then select the tests to run.

  1. To display more tests (since the window displays only 80 tests at a time), select 1-80, 81-160, 161-240, 241-320, or 321-326.

  2. Select Return.

  3. When prompted, select Yes to return to the Start Conditions window.

The Temp item select button text is now blue, indicating the changes will be used.

note

If you temporarily deselect a test, the test will not run as part of autocalibration and autocontrol settings.