System Specification Settings window

Use this window to enter settings related to the system configuration.

Setting the system specifications

1. Log on as supervisor.

2. At the Menu Panel, select Setup, then select System Specifications Settings.

3. At the System Specifications Settings window, enter or change settings for the areas listed below:

·   Settings that take effect after the next New Start

Basic system components - these settings allow you to customize general components of the system:

Basic system operation - these settings are used for retesting samples:

·   Settings that take effect after startup operation from Ready state

·   Serum indices specifications

Various System Operation Setting - The settings below are related to serum information items (serum indices), used when creating workorders. If you did not select the serum indices for each sample in the Order Entry window, select one of these settings:

Request. test range

Compulsory test analysis

Not handled

Sample containers specifications  - the settings below specify the sample containers used by the system. You can specify up to 9 container types.

 caution

Normal operation and the volume of sample aspirated depends on the specifications you enter here. Incorrect settings may damage the DPP and nozzles.

Reagent Bottle Specifications- The settings below specify the reagent bottles used by the system. These settings are used in the Reagent Inventory, Reagent Container Settings, and Lamp Energy Monitor windows.

 caution

Incorrect settings may result in abnormal data.

4. To save the settings, select Save.

Related topics

Setting the system monitor

Setting system parameters